HP 6125G - Reset Ip Ip-Prefix; Ipv6 Routing Policy Configuration Commands; Apply Ipv6 Next-Hop

358
Examples
# Define IP prefix list p1 to permit routes matching network 10.0.192.0/8 and with mask length 17 or 18.
<Sysname> system-view
[Sysname] ip ip-prefix p1 permit 10.0.192.0 8 greater-equal 17 less-equal 18
reset ip ip-prefix
Syntax
reset ip ip-prefix [ ip-prefix-name ]
View
User view
Default level
2: System level
Parameters
ip-prefix-name: IP prefix list name, a string of 1 to 19 characters.
Description
Use reset ip ip-prefix to clear the statistics of a specified IPv4 prefix list. If no ip-prefix-name is specified,
the statistics of all IPv4 prefix lists will be cleared.
Examples
# Clear the statistics of IPv4 prefix list abc.
<Sysname> reset ip ip-prefix abc
IPv6 routing policy configuration commands
apply ipv6 next-hop
Syntax
apply ipv6 next-hop ipv6-address
undo apply ipv6 next-hop
View
Routing policy view
Default level
2: System level
Parameters
ipv6-address: Next hop IPv6 address.
Description
Use apply ipv6 next-hop to configure a next hop for IPv6 routes.
Use undo apply ipv6 next-hop to remove the clause configuration.
No next hop address is configured for IPv6 routing information by default.