120
Parameters
interface-type interface-number: Specifies an interface by its type and number.
all: Specifies all interfaces.
Description
Use silent-interface to disable an interface or all interfaces from receiving and sending OSPF packets.
Use undo silent-interface to restore the default.
By default, an interface can receive send OSPF packets.
A disabled interface is a passive interface, which cannot receive and send any hello packet.
To make no routing information obtained by other routers on a network segment, you can use this
command to disable the interface from receiving and sending OSPF packets.
Examples
# Disable an interface from receiving and sending OSPF packets.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] silent-interface vlan-interface 10
snmp-agent trap enable ospf
Syntax
snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange |
iftxretransmit | lsdbapproachoverflow | lsdboverflow | maxagelsa | nbrstatechange | originatelsa |
vifcfgerror | virifauthfail | virifrxbadpkt | virifstatechange | viriftxretransmit | virnbrstatechange ] *
undo snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange |
iftxretransmit | lsdbapproachoverflow | lsdboverflow | maxagelsa | nbrstatechange | originatelsa |
vifcfgerror | virifauthfail | virifrxbadpkt | virifstatechange | viriftxretransmit | virnbrstatechange ] *
View
System view
Default level
3: Manage level
Parameters
process-id: OSPF process ID, in the range of 1 to 65535.
ifauthfail: Interface authentication failure information.
ifcfgerror: Interface configuration error information.
ifrxbadpkt: Information about error packets received.
ifstatechange: Interface state change information.
iftxretransmit: Packet receiving and forwarding information.
lsdbapproachoverflow: Information about cases approaching LSDB overflow.
lsdboverflow: LSDB overflow information.
maxagelsa: LSA max age information.
To Next Page
Loading...
Need help?
General