303
short-cut: If the keyword is specified for an EBGP route, the route will use the local routing management
value rather than that of EBGP routes, so the preference of the route is reduced.
Description
Use network to advertise a network to the IPv6 BGP routing table.
Use undo network to remove an entry from the IPv6 BGP routing table.
By default, no route is advertised.
The route to be advertised must exist in the local IP routing table, and using a routing policy makes route
management more flexible.
The route advertised to the BGP routing table using the network command has the IGP origin attribute.
Examples
# Advertise the network 2002::/16 into the IPv6 BGP routing table.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] network 2002:: 16
peer advertise-community (IPv6 address family view)
Syntax
peer { group-name | ipv4-address | ipv6-address } advertise-community
undo peer { group-name | ipv4-address | ipv6-address } advertise-community
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
Description
Use peer advertise-community to advertise the COMMUNITY attribute to a peer/peer group.
Use undo peer advertise-community to remove the configuration.
By default, no COMMUNITY attribute is advertised to any peer group/peer.
Examples
# Advertise the COMMUNITY attribute to the peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 advertise-community
To Next Page
Loading...
Need help?
General