HP 6125G - Peer Reflect-Client (Ipv6 Address Family View); Peer Route-Limit (Ipv6 Address Family View)

322
By default, BGP updates carry the private AS number.
The command does not take effect if the BGP update has both the public AS number and private AS
number. The range of private AS number is from 64512 to 65535.
Examples
# Configure BGP updates sent to the peer 1:2::3:4 to not carry private AS numbers.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 public-as-only
peer reflect-client (IPv6 address family view)
Syntax
peer { group-name | ipv4-address | ipv6-address } reflect-client
undo peer { group-name | ipv4-address | ipv6-address } reflect-client
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
Description
Use peer reflect-client to configure the router as a route reflector and specify a peer/peer group as a
client.
Use undo peer reflect-client to remove the configuration.
By default, neither route reflector nor client is configured.
Related commands: reflect between-clients and reflector cluster-id.
Examples
# Configure the local device as a route reflector and specify the peer group test as a client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test
[Sysname-bgp-af-ipv6] peer test reflect-client
peer route-limit (IPv6 address family view)
Syntax
peer { group-name | ipv4-address | ipv6-address } route-limit prefix-number [ { alert-only | reconnect
reconnect-time } | percentage ] *