Default route
• Only/Originate—Only means that the interface
advertises only the default route. Originate means
that the default route and other RIPng routes are
advertised.
• Off—Indicates that no default route is advertised
or the garbage-collect time expires after the default
route advertisement was disabled.
• In garbage-collect status—With default route
advertisement disabled, the interface advertises
the default route with metric 16 during the
garbage-collect time.
Summary address
The summarized IPv6 prefix and the summary IPv6
prefix on the interface.
display ripng route
Syntax
display ripng process-id route [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display ripng route to display all RIPng routes and timers associated with each route of a RIPng
process.
Examples
# Display the routing information of RIPng process 100.
<Sysname> display ripng 100 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::200:5EFF:FE04:B602 on Vlan-interface11
Dest 3FFE:C00:C18:1::/64,
via FE80::200:5EFF:FE04:B602, cost 2, tag 0, A, 34 Sec
To Next Page
Loading...
