44
• If no preference is set by the routing policy, the preference of all RIP routes is set by the preference
command.
Examples
# Set the RIP route preference to 120.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] preference 120
reset rip process
Syntax
reset rip process-id process
View
User view
Default level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use reset rip process to reset the specified RIP process.
After executing the command, you are prompted whether you want to reset the RIP process.
Examples
# Reset RIP process 100.
<Sysname> reset rip 100 process
Warning : Reset RIP process? [Y/N]:Y
reset rip statistics
Syntax
reset rip process-id statistics
View
User view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use reset rip statistics to clear the statistics of the specified RIP process. This command can clear the
statistics of debugging.
Examples
# Clear statistics in RIP process 100.
To Next Page
Loading...
