EasyManuals Logo

HP 6125G User Manual

HP 6125G
410 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
124
count: Maximum number of LSU packets sent by an interface at each interval. It is in the range of 1 to
200. If the router has a number of OSPF interfaces, HP recommends decreasing this interval to reduce
the total numbers of LSU packets sent by the router every second.
Description
Use transmit-pacing to configure the maximum number of LSU packets that can be sent every the
specified interval.
Use undo transmit-pacing to restore the default.
By default, an OSPF interface sends up to three LSU packets every 20 milliseconds.
Examples
# Configure all the interfaces under OSPF process 1 to send up to 10 LSU packets every 30 milliseconds.
<Sysname> system-view
[Sysname] ospf 1
[Sysname-ospf-1] transmit-pacing interval 30 count 10
vlink-peer (OSPF area view)
Syntax
vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds | dead seconds | simple
[ cipher | plain ] password | { md5 | hmac-md5 } key-id [ cipher | plain ] password ] *
undo vlink-peer router-id [ hello | retransmit | trans-delay | dead | [ simple | { md5 | hmac-md5 }
key-id ] ] *
View
OSPF area view
Default level
2: System level
Parameters
router-id: Router ID of the neighbor on the virtual link.
hello seconds: Hello interval in seconds, in the range of 1 to 8192. The default is 10. It must be identical
to the hello interval on the virtual link neighbor.
retransmit seconds: Retransmission interval in seconds, in the range of 1 to 3600. The default is 5.
trans-delay seconds: Transmission delay interval in seconds, in the range of 1 to 3600. The default is 1.
dead seconds: Dead interval in seconds, in the range of 1 to 32768. The default is 40. It must be
identical to that on the virtual link neighbor. The dead interval is at least four times the hello interval.
md5: MD5 authentication.
hmac-md5: HMAC-MD5 authentication.
simple: Simple authentication.
key-id: Key ID for MD5 or HMAC-MD5 authentication, in the range of 1 to 255.
ciper: Sets a ciphertext password.
plain: Sets a plaintext password.

Table of Contents

Other manuals for HP 6125G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 6125G and is the answer not in the manual?

HP 6125G Specifications

General IconGeneral
BrandHP
Model6125G
CategorySwitch
LanguageEnglish

Related product manuals