HP 6125G - Peer Preferred-Value (BGP;BGP-VPN Instance View)

189
Examples
# In BGP view, perform MD5 authentication on the TCP connection set up between the local router
10 .1.10 0 .1 a n d t h e p e e r r o u t e r 10 .1.10 0 . 2.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer 10.1.100.2 password simple aabbcc
# Perform the similar configuration on the peer.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer 10.1.100.1 password simple aabbcc
# In BGP-VPN instance view, perform MD5 authentication on the TCP connection set up between the
l o c a l r o u t e r 10 .1.10 0 .1 a n d t h e p e e r r o u t e r 10 .1.10 0 . 2. ( T h e V P N h a s b e e n c r e a t e d . )
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer 10.1.100.2 password simple aabbcc
# Perform the similar configuration on the peer.
<Sysname> system-view
[Sysname] bgp 200
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer 10.1.100.1 password simple aabbcc
peer preferred-value (BGP/BGP-VPN instance view)
Syntax
peer { group-name | ip-address } preferred-value value
undo peer { group-name | ip-address } preferred-value
View
BGP view, BGP-VPN instance view
Default level
2: System level
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
value: Preferred value, in the range of 0 to 65535.
Description
Use peer preferred-value to assign a preferred value to routes received from a peer or peer group.
Use undo peer preferred-value to restore the default value.
The default preferred value is 0.
Routes learned from a peer have an initial preferred value. Among multiple routes that have the same
destination/mask and are learned from different peers, the one with the greatest preferred value is
selected as the route to the destination.