88
Cost: 1562 State: P-2-P Type: Virtual
Transit Area: 0.0.0.1
Timers: Hello 10 , Dead 40 , Retransmit 5 , Transmit Delay 1
Table 27 Command output
Field Descri
Virtual-link Neighbor-ID ID of the neighbor on the virtual link
Neighbor-State Neighbor State: Down, Init, 2-Way, ExStart, Exchange, Loading, Full.
Interface IP address and name of the local interface on the virtual link
Cost Interface route cost
State Interface state
Type Type: virtual link
Transit Area Transit area ID
Timers Values of timers: hello, dead, retransmit, and interface transmission delay
display router id
Syntax
display router id [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display router id to display the global router ID.
Examples
# Display the global router ID.
<Sysname> display router id
Configured router ID is 1.1.1.1
To Next Page
Loading...
Need help?
General