389
Description
Use vpn-instance-capability simple to disable routing loop detection for a VPN OSPF process.
Use undo vpn-instance-capability to restore the default.
By default, the loop detection function is enabled for a VPN OSPF process.
Examples
# Disable routing loop detecton for the VPN OSPF process 100.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpna
[Sysname-ospf-100] vpn-instance-capability simple
vpn-target
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
View
VPN instance view
Default level
2: System level
Parameters
vpn-target&<1-8>: Adds VPN target extended community attributes to the import VPN target extended
community attribute list (Import Target) or export VPN target extended community attribute list (Export
Target). &<1-8> means that you can add up to eight VPN targets.
A VPN target attribute can be a string of 3 to 21 characters in one the following formats:
• 16-bit AS number:32-bit user-defined number. For example, 101:3.
• 32-bit IP address:16-bit user-defined number. For example, 192.168.122.15:1.
• 32-bit AS number:16-bit user-defined number, where the AS number must not be less than 65536.
For example, 65536:1.
both: Uses the specified VPN targets as both import targets and export targets. The both keyword is also
used when you do not specify any of both, export-extcommunity, and import-extcommunity.
export-extcommunity: Uses the specified VPN targets as export targets.
import-extcommunity: Uses the specified VPN targets as import targets.
all: Removes all VPN targets.
Description
Use vpn-target to configure VPN targets for a VPN instance.
Use undo vpn-target to remove the specified or all VPN targets of a VPN instance.
By default, no VPN targets are configured for a VPN instance. You must configure VPN targets when
creating a VPN instance.
Examples
# Configure VPN targets for VPN instance vpn1.
To Next Page
Loading...
Need help?
General