39
[Sysname] rip 1
[Sysname-rip-1] filter-policy 2000 import
# Reference IP prefix list abc on Vlan-interface 11 to filter all received RIP routes.
[Sysname-rip-1] filter-policy ip-prefix abc import Vlan-interface 11
# Configure ACL 3000 to permit only route 113.0.0.0/16 to pass, and reference ACL 3000 to filter
incoming routes.
<Sysname> system-view
[Sysname] acl number 3000
[Sysname-acl-adv-3000] rule 10 permit ip source 113.0.0.0 0 destination 255.255.0.0 0
[Sysname-acl-adv-3000] rule 100 deny ip
[Sysname-acl-adv-3000] quit
[Sysname] rip 1
[Sysname-rip-1] filter-policy 3000 import
host-route
Syntax
host-route
undo host-route
View
RIP view
Default level
2: System level
Parameters
None
Description
Use host-route to enable host route reception.
Use undo host-route to disable host route reception.
By default, receiving host routes is enabled.
In some cases, a router may receive many host routes from the same network segment. These routes are
not helpful for routing and occupy a large amount of network resources. Use undo host-route to disable
receiving of host routes.
RIPv2 can be disabled from receiving host routes, but RIPv1 cannot.
Examples
# Disable RIP from receiving host routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] undo host-route
To Next Page
Loading...
