221
After you execute this command, the generated RIPng default route is advertised in a route update over
the specified interface. This IPv6 default route is advertised without considering whether it already exists
in the local IPv6 routing table.
Examples
# Advertise only the default route through VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng default-route only
# Advertise the default route together with other routes through VLAN-interface 101.
<Sysname> system-view
[Sysname] interface vlan-interface 101
[Sysname-Vlan-interface101] ripng default-route originate
ripng enable
Syntax
ripng process-id enable
undo ripng [ process-id ] enable
View
Interface view
Default level
2: System level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Description
Use ripng enable to enable RIPng on the specified interface.
Use undo ripng enable to disable RIPng on the specified interface.
By default, RIPng is disabled on an interface.
Examples
# Enable RIPng100 on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng 100 enable
ripng metricin
Syntax
ripng metricin value
undo ripng metricin
View
Interface view
To Next Page
Loading...
