205
If neither the holdtime interval nor the keepalive interval is configured as 0, the holdtime interval must be
at least three times the keepalive interval.
The configured timers apply to all BGP peers, but they become valid for a BGP peer only after the
relevant BGP connection is reset.
After this command is executed, no peer connection is closed at once. The configured hold time is used
for negotiation when a peer relationship is reestablished.
Related commands: peer timer.
Examples
# Configure keepalive interval and holdtime interval as 60s and 180s.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] timer keepalive 60 hold 180
# In BGP-VPN instance view, configure keepalive interval and holdtime interval as 60s and 180s. (The
VPN has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] timer keepalive 60 hold 180
# In BGP view, configure both the BGP keepalive interval and holdtime interval as 0 seconds, indicating
no peer connection will time out.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] timer keepalive 0 hold 0
# In BGP-VPN instance view, configure both the keepalive interval and holdtime interval for vpn1 as 0
seconds, indicating no peer connection will time out. (vpn1 must have been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] timer keepalive 0 hold 0
To Next Page
Loading...
Need help?
General