241
area-id: The ID of an area, a decimal integer that is translated into IPv4 address format by the system (in
the range of 0 to 4294967295) or an IPv4 address.
interface-type interface-number: Specifies an interface by its type and number.
verbose: Display detailed neighbor information.
peer-router-id: Router-ID of the specified neighbor.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display ospfv3 peer to display OSPFv3 neighbor information.
• If no area-id is specified, the neighbor information of all areas is displayed.
• If no interface or neighbor Router-ID is specified, the neighbor information of all interfaces is
displayed.
Examples
# Display the neighbor information of OSPFv3 process 1 on an interface.
<Sysname> display ospfv3 1 peer vlan-interface 10
OSPFv3 Process (1)
Neighbor ID Pri State Dead Time Interface Instance ID
1.1.1.1 1 Full/ - 00:00:30 vlan10 0
Table 53 Command output
Field Descri
Neighbor ID Router ID of a neighbor
Pri Priority of neighbor router
State Neighbor state
Dead Time Dead time remained
Interface Interface connected to the neighbor
Instance ID Instance ID
# Display detailed neighbor information of OSPFv3 process 100 of an interface.
<Sysname> display ospfv3 1 peer vlan-interface 33 verbose
OSPFv3 Process (1)
Neighbor 1.1.1.1 is Full, interface address FE80::20F:E2FF:FE49:8050
In the area 0.0.0.1 via interface Vlan-interface33
DR is 1.1.1.1 BDR is 2.2.2.2
Options is 0x000013 (-|R|-|-|E|V6)
Dead timer due in 00:00:39
Neighbor is up for 00:25:31
To Next Page
Loading...
Need help?
General