69
SPF Scheduled Count: 5
ExChange/Loading Neighbors: 0
Interface: 192.168.1.2 (Vlan-interface11)
Cost: 1 State: DR Type: Broadcast MTU: 1500
Priority: 1
Designated Router: 192.168.1.2
Backup Designated Router: 192.168.1.1
Timers: Hello 10 , Dead 40 , Poll 40 , Retransmit 5 , Transmit Delay 1
Table 14 Command output
Field Descri
OSPF Process 1 with Router ID 192.168.1.2
OSPF process ID and OSPF router ID.
RouterID Router ID.
Router Type
Router type:
• ABR
• ASBR
• NSSA
• Null
Route Tag The tag of redistributed routes.
Multi-VPN-Instance is not enabled The OSPF process does not support multi-VPN-instance.
SPF-schedule-interval Interval for SPF calculations.
LSA generation interval LSA generation interval.
LSA arrival interval LSA arrival interval.
Transmit pacing
LSU packet transmit rate of the interface:
• Interval—Indicates the LSU transmit interval of the interface.
• Count—Indicates the maximum number of LSU packets sent
at each interval.
Default ASE Parameter Default ASE Parameters: metric, tag, route type.
Route Preference Internal route priority.
ASE Route Preference External route priority.
SPF Computation count SPF computation count of the OSPF process.
RFC1583 Compatible Compatible with routing rules defined in RFC 1583.
Area Count Area number of the current process.
Nssa Area Count NSSA area number of the current process.
7/5 translator state
State of the translator that translates Type-7 LSAs to Type-5
LSAs. The value can be one of the following:
• Enabled—Indicates the translator is specified through
commands.
• Elected—Indicates the translator is designated through
election.
• Disabled—Indicates the device is not a translator that
translates Type-7 LSAs to Type-5 LSAs.
To Next Page
Loading...
