80
Default level
1: Monitor level
Parameters
process-id: OSPF process ID, in the range of 1 to 65535.
verbose: Displays detailed neighbor information.
interface-type interface-number: Specifies an interface by its type and number.
neighbor-id: Neighbor router ID.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display ospf peer to display information about OSPF neighbors.
If no OSPF process is specified, OSPF neighbor information of all OSPF processes is displayed.
If an interface is specified, the neighbor on the interface is displayed.
If a neighbor ID is specified, detailed information about the neighbor is displayed,
If neither interface nor neighbor ID is specified, brief information about neighbors of the specified OSPF
process or all OSPF processes is displayed.
Examples
# Display detailed OSPF neighbor information.
<Sysname> display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.1
Neighbors
Area 0.0.0.0 interface 1.1.1.1(Vlan-interface11)'s neighbors
Router ID: 1.1.1.2 Address: 1.1.1.2 GR State: Normal
State: Full Mode: Nbr is Master Priority: 1
DR: 1.1.1.2 BDR: 1.1.1.1 MTU: 0
Dead timer due in 33 sec
Neighbor is up for 02:03:35
Authentication Sequence: [ 0 ]
Neighbor state change count: 6
To Next Page
Loading...
Need help?
General