To Next Page

To Previous Page

Web overview

The device provides Web-based configuration interfaces for visual device management and

maintenance.

Figure 1 Web-based network management operating environment

Logging in to the Web interface

Follow these guidelines when you log in to the Web interface:

• The PC in Figure 1 i

s the one where you configure the device, but not necessarily the Web-based

network management terminal. The Web-based network management terminal is a PC (or another

terminal) used to log in to the Web interface and is required to be reachable to the device.

• If you click the verification code displayed on the Web login page, you can get a new verification

code.

• Up to 24 users can concurrently log in to the device through the Web interface.

• You can also log in to the Web interface through HTTPS, but you must enable HTTPS on the device,

and the address you input in the address bar must start with https://. For more information, see

"Configuring service management."

• If you have configured the auto authentication mode for an HTTPS login user by using the web

https-authorization mode command, the user is automatically authenticated by the PKI certificate,

without inputting any username and password. For more information, see Fundamentals

Configuration Guide.

You can use the following default settings to log in to the Web interface through HTTP:

• Username—admin.

• Password—admin.

• IP address of the device— 19 2 .16 8 .1.1.

To log in to the Web interface of the device from a PC:

1. Connect the Ethernet interface Ethernet 0/0 of the device to the PC using a crossover Ethernet

cable.

2. Configure an IP address for the PC and make sure the PC and device can reach each other.

For example, assign the PC an IP address (for example, 192.168.1.2) within the network segment

192.168.1.0/24 (except for 192.168.1.1).

3. Open the browser, and input the login information.

a. Type the IP address http://192.168.1.1 in the address bar and press Enter.

The login page of the Web interface (see

Figure 2) appears.

b. Enter the username and password admin, and the verification code, select the language

(English and Chinese are supported at present), and click Login.

HP MSR SERIES User Manual

Other manuals for HP MSR SERIES