HP MSR SERIES User Manual

237
Table 115 Configuration items
Item Descri
p
tion
Start Address
Set the address range of the subnet where rate limit is to be performed.
End Address
Interface Specify the interface to which the subnet limit is to be applied.
CIR Set the average traffic rate allowed.
Type
Set the rate limit method:
• Share—Limits the total rate of traffic for all IP addresses on the subnet, and
dynamically allocates bandwidth to an IP address based on traffic size.
• Per IP—Individually limits the rate of traffic of each IP address on the subnet to the
configured rate.
Direction
Set the direction where the rate limit applies:
• Download—Limits the rate of incoming packets of the interface based on their
destination IP addresses.
• Upload—Limits the rate of outgoing packets of the interface based on their source
IP addresses.
Configuring advanced limit
Select Advance > QoS Setup > Advanced Limit from the navigation tree. Click Add to enter the Advanced
Limit Setting page.
Figure 240 Advanced limit

HP MSR SERIES Specifications

General

Product Series	MSR Series
Manufacturer	HP
Category	Network Router
Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Varies by model
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Weight	Varies by model
Wireless Support	Varies by model
Management	Web-based, CLI
Power Supply	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing