HP MSR SERIES - Call Authority Control

733
You can configure up to eight call-in number prefixes. The local SIP server adopts longest match to deal
with a called number.
Call authority control
Configure a call rule set
Select Voice Management > SIP Local Survival > Call Authority Control from the navigation tree, and
click Add to access the page as shown in Figure 755.
Figure 755 Configuring a call rule set
Table 282 Configuration items
Item Descri
p
tion
Rule Set ID Enter the ID of the call rule set.
Rule
Rule ID Enter the rule ID.
Call Direction
• Outgoing—Applies the rule to outgoing calls.
• Incoming—Applies the call to incoming calls.
Call Authority
• Permit— Permits the matching calls.
• Deny—Denies the matching calls.
Number Pattern
Enter the number match pattern.
A dot can be used after a number to represent a character. This configuration does
not support other characters.
Apply the call rule set
Select Voice Management > SIP Local Survival > Call Authority Control from the navigation tree, and
click the icon of the call rule set to access the page as shown in Figure 756.