HP MSR SERIES User Manual

571
Figure 592 Configuring call transfer
Verifying the configuration
The whole process is as follows:
1. Call Telephone B from Telephone A, and then Telephone B and Telephone A are in a conversation.
2. Perform a hookflash at Telephone A to put the call with Telephone B on hold.
3. Call Telephone C (3000) from Telephone A after hearing dial tones.
4. Hang up Telephone A.
5. Telephone B and Telephone C are in a conversation and call transfer is completed.
Configuring hunt group
Network requirements
As shown in Figure 593, hunt group applies to the situation where multiple subscriber lines correspond
to the same number. When the voice subscriber line with the first highest priority is in use, the device can
automatically connect an incoming call to the voice subscriber line with the second highest priority.
Telephone A1 (1000) and Telephone A2 (1000) are both connected to Router A, and Telephone A1 has
a higher priority. Dial number 1000 from Telephone B (2000). Because Telephone A1 has a higher
priority, Telephone B is connected to Telephone A1. If number 1000 is dialed from Telephone C (3000)
when Telephone A1 and Telephone B are in a conversation, hunt group enables Telephone C to have a
conversation with Telephone A2.

HP MSR SERIES Specifications

General

Product Series	MSR Series
Manufacturer	HP
Category	Network Router
Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Varies by model
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Weight	Varies by model
Wireless Support	Varies by model
Management	Web-based, CLI
Power Supply	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing