HP MSR SERIES - DHCP Relay Agent Configuration Example

220
Figure 225 Enabling the DHCP client on interface Ethernet 0/1
DHCP relay agent configuration example
Network requirements
Ethernet 0/1 on the DHCP relay agent (Router A) connects to the network where DHCP clients reside. The
IP address of Ethernet 0/1 is 10.10.1.1/24 and IP address of Ethernet 0/2 is 10.1.1.2/24 that connects
t o t h e D H C P s e r v e r 10 .1.1.1 / 2 4 ( R o u t e r B ) .
Router A forwards DHCP messages so that the DHCP clients on the network segment 10.10.1.0/24 can
obtain IP addresses, DNS server address and gateway address from the DHCP server. The IP address
lease is seven days, the domain name suffix is aabbcc.com, the DNS server address is 10.10.1.2/24,
and the gateway address is 10.10.1.126/24.
Figure 226 Network diagram
Configuring the DHCP relay agent (Router A)
1. Specify IP addresses for interfaces (details not shown).
2. Enable DHCP:
a. Select Advanced > DHCP Setup from the navigation tree of Router A
The default DHCP Enable tab appears.