650
Table 253 Configuration items
Item Descri
tion
TCP Connection
Aging Time
Set the aging time for TCP connections. If the idle time of an established TCP
connection reaches the specified aging time, the connection will be closed.
TLS Connection Aging
Time
Set the aging time for TLS connections. If the idle time of an established TLS connection
reaches the specified aging time, the connection will be closed.
Configuring call release cause code mapping
No matter whether a voice call is cleared normally or abnormally, a message with the call release cause
code will be sent. The default SIP status code to PSTN release cause code mappings and PSTN release
cause code to SIP status mappings are used for communication between a SIP network and a PSTN. To
adapt to more complex network applications, you can change the default mappings.
Configuring PSTN call release cause code mappings
Select Voice Management > Call Connection > SIP Connection from the navigation tree, and click the
PSTN Release Cause Code Mapping tab to access the configuration page shown in Figure 672.
Figure 672 PSTN release cause code mapping configuration page
You can enter the SIP status code into the corresponding SIP Status Code (400-699) field. Because the
PSTN release cause code 16 corresponds to a SIP request message, instead of a SIP status code, you can
configure no SIP status code for 16.
Click Load Default Value to restore the default mappings between PSTN release cause codes and SIP
status codes.