To Next Page

To Previous Page

777

a. Type 30000 for Number ID.

b. Type 300 for Number.

c. Select call500 from the Bind to Menu list.

d. Click Apply.

For other settings, see Configuring Router B.

Verifying the configuration

Dial 300 at Telephone A. Telephone B rings.

Configure a secondary call on a service node

Network requirements

As shown in Figure 805, configure an IVR access number and service node functions on Router B to meet

the following requirements.

• After the subscriber dials 300 (the IVR access number) from Telephone A, Router B plays the audio

file bye.wav, and then terminates the call.

• If the subscriber dials a wrong number at Telephone A, Router B plays the audio file

input_error.wav.

• If no number is dialed at Telephone A within the timeout time, Router B plays the audio file

timeout.wav.

Figure 805 Network diagram

Configuration procedure

1. Configure Router A: See Configuring Router A.

2. Configure Router B:

# Configure a service node.

Select Voice Management > IVR Services > Advanced Settings from the navigation tree, select the

Configure Service Node tab, and click Add to access the following page.

Other manuals for HP MSR SERIES

Questions and Answers:

Need help?

Do you have a question about the HP MSR SERIES and is the answer not in the manual?

General