76
Item Descri
tion
Domain
Select an existing domain from the list.
The default domain is system. To create a domain, select Authentication > AAA
from the navigation tree, click the Domain Setup tab, and type a new domain
name in the Domain Name field.
• The selected domain name applies to only the current wireless service, and all
clients accessing the wireless service use this domain for authentication,
authorization, and accounting.
• Do not delete a domain name in use. Otherwise, the clients that access the
wireless service will be logged out.
Preshared Key
• pass-phrase—Enter a PSK in the form of a character string. You should enter a
string that can be displayed and is of 8 to 63 characters.
• raw-key—Enter a PSK in the form of a hexadecimal number. You should input
a valid 64-bit hexadecimal number.
4. Configure psk:
Figure 49 Configuring psk port security
Table 49 Configuration items
Item Descri
tion
Port Mode
psk: An access user must use the pre-shared key (PSK) that is pre-configured
to negotiate with the device. The access to the port is allowed only after the
negotiation succeeds.
Max User
Control the maximum number of users allowed to access the network through
the port.
Preshared Key
• pass-phrase—Enter a PSK in the form of a character string. Enter a string
that can be displayed and is of 8 to 63 characters.
• raw-key—Enter a PSK in the form of a hexadecimal number. Enter a valid
64-bit hexadecimal number.
5. Configure userlogin-secure-ext:
Perform the configurations as shown in Configure userlogin-secure/userlogin-secure-ext.
Binding an AP radio to a wireless service
1. Select Interface Setup > Wireless > Access Service from the navigation tree.
To Next Page
Loading...
Need help?
General
