773
Verifying the configuration
1. Dial 300 at Telephone A.
Router B plays the audio file welcome.wav.
2. Dial 0.
Telephone B rings.
Configure a jump node
Network requirements
As shown in Figure 800, configure an IVR access number and jump node functions on Router B to meet
the following requirements.
• After the subscriber dials 300 (the IVR access number) from Telephone A, Router B plays the audio
file welcome.wav. Then if the subscriber dials #, Router B terminates the call.
• If the subscriber dials a wrong number at Telephone A, Router B plays the audio file
input_error.wav.
• If no number is dialed at Telephone A within the timeout time, Router B plays the audio file
timeout.wav.
Figure 800 Network diagram
Configuration procedure
1. Configure Router A: See Configuring Router A.
2. Configure Router B:
# Configure a jump node.
Select Voice Management > IVR Services > Advanced Settings from the navigation tree, select the
Configure Jump Node tab, and click Add to access the following page.
To Next Page
Loading...
