To Next Page

To Previous Page

490

• CPE address

• CPE username

• CPE password

For the TR-069 mechanism, see Network Management and Monitoring Configuration Guide in HP MSR

Router Series Configuration Guides (V5).

Configuration procedure

The TR-069 parameters of CPE can be configured automatically through ACS remote management, and

also can be configured manually through Web, which is described in detail in this section.

To configure TR-069 manually:

1. From the navigation tree, select System Management > TR-069.

The TR-069 configuration page appears.

2. Configure TR-069 as described in Table 198.

3. Cli

ck Apply.

Figure 518 TR-069 configuration page

Table 198 Configuration items

Item Descri

tion

TR-069

Enable or disable TR-069.

TR-069 configurations can take effect only after you enable TR-069.

ACS

URL. Configure the URL used by a CPE to initiate a connection to the ACS.

Username. Configure the username used by a CPE to initiate a connection to the ACS.

Password.

Configure the password used by a CPE to initiate a connection to the ACS.

You can specify a username without a password that is used in the authentication.

If so, the configuration on the ACS and that on the CPE must be the same.

CPE Username.

Configure the username used by the CPE to authenticate the connection sent from

the ACS.

Other manuals for HP MSR SERIES

Questions and Answers:

Need help?

Do you have a question about the HP MSR SERIES and is the answer not in the manual?

General