HP MSR SERIES - Configuring Advanced Queue; Configuring Interface Bandwidth

240
Configuring advanced queue
To use the advanced queue function on tunnel interfaces, sub-interfaces, or VT and dialer interfaces with
PPPoE, PPPoA, PPPoEoA, or PPPoFR at the data link layer, you must configure interface bandwidth for
these interfaces.
Configuring interface bandwidth
Select Advance > QoS Setup > Advanced Queue from the navigation tree to enter the Advanced Queue
page. Select an interface from the Interface Name list, and then configure and view the CIR of the
interface.
Figure 242 Advanced queue
Table 117 Configuration items
Item Descri
p
tion
Interface Name Select the interface to be configured.