184
Configuring user-based load sharing
You can configure user-based load sharing through the Web interface.
Overview
A routing protocol can have multiple equal-cost routes to the same destination. These routes have the
same preference, and are all used to accomplish load sharing if no route with a higher preference is
available.
The device supports user-based load sharing based on the user information (source IP addresses) of
packets.
Configuration procedure
1. Select Advanced > User-based-sharing from the navigation tree.
The user-based load sharing page appears.
Figure 188 User-based load sharing
2. Click the icon of an interface.
The Modify configuration page appears.
Figure 189 Modifying configuration
3. Configure the parameters as described in Table 100.
To Next Page
Loading...
