HP MSR SERIES - Page 238

221
b. Select the Enable option in the DHCP field.
c. Click Apply.
Figure 227 DHCP enable
3. Create a DHCP server group:
a. Click the DHCP Interface Setup tab.
b. Select Ethernet0/1 from the Interface list.
c. Select the Relay option in the Type field.
d. Expand the Add DHCP Server Group node.
e. Enter 1 in the Group ID field.
f. Enter 10.1.1.1 in the Server IP Address field.
g. Click Apply.
Figure 228 DHCP server group creating
4. Enable the DHCP relay agent on interface Ethernet 0/1.