To Next Page

To Previous Page

333

 If you remove an authentication or accounting server in use, the communication of the device

with the server will soon time out, and the device will look for a server in the active state by

checking any primary server first and then the secondary servers in the order they are

configured.

 When the primary server and secondary servers are all in the blocked state, the device

communicates with the primary server. If the primary server is available, its statues changes to

active. Otherwise, its status remains to be blocked.

 If one server is in the active state but all the others are in the blocked state, the device only tries

to communicate with the server in the active state, even if the server is unavailable.

 After receiving an authentication/accounting response from a server, the device changes the

status of the server identified by the source IP address of the response to active if the current

status of the server is blocked.

• Set the real-time accounting interval based on the number of users.

Table 149 Recommended real-time accounting intervals

Number of users

Real-time accountin

interval (in minutes)

1 to 99 3

100 to 499 6

500 to 999 12

>=1000 >=15

Other manuals for HP MSR SERIES

Questions and Answers:

Need help?

Do you have a question about the HP MSR SERIES and is the answer not in the manual?

General