563
Figure 584 Call services configuration page
Table 213 Configuration items
Item Descri
tion
Call Forwarding
The Forwarded-to Number for Call Forwarding no Reply—Enter the forwarded-to
number for call forwarding no reply.
The Forwarded-to Number for Call Forwarding Busy—Enter the forwarded-to number
for call forwarding busy.
Call Forwarding Unconditional—Enter the forwarded-to number for forwarding
unconditional.
The Forwarded-to Number for Call Forwarding Unavailable—Enter the forwarded-to
number for call forwarding unavailable.
Call Waiting
After call waiting is enabled, configure the following parameters according to your
needs:
• Number of Call Waiting Tone Play Times.
• Number of Tones Played at One Time.
• Interval for Playing Call Waiting Tones.
By default, two call waiting tones are played once, and if the value of Number of
Tones in a Call Waiting Tone is greater than 1, the Interval for Playing Call Waiting
Tones is 15 seconds.
Call Hold Enable or disable the call hold function.
Call Transfer
Call hold must be enabled before call transfer.
After call transfer is enabled, you can set the Call Transfer Start Delay parameter
according to your needs.
Three-Party
Conference
The three-party conference function depends on the call hold function. Therefore, you
must enable the call hold function before configuring three-party conference.
Monitor and Barge In Enable or disable the silent-monitor and barge in services.
To Next Page
Loading...
Need help?
General
