119
Figure 100 Create an SNMP view (2)
3. Configure the parameters of a rule and click Add to add the rule into the list box at the lower part
of the page.
4. Configure all rules and click Apply to crate an SNMP view. Note that the view will not be created
if you click Cancel.
Table 43 Configuration items for creating an SNMP view
Item Descri
View Name Set the SNMP view name.
Rule
Select to exclude or include the objects in the view range determined by the MIB
subtree OID and subtree mask.
MIB Subtree OID
Set the MIB subtree OID (such as 1.4.5.3.1) or name (such as system).
MIB subtree OID identifies the position of a node in the MIB tree, and it can uniquely
identify a MIB subtree.
Subtree Mask
Set the subtree mask.
If no subtree mask is specified, the default subtree mask (all Fs) will be used for
mask-OID matching.
Adding rules to an SNMP view
1. Click the icon corresponding to the specified view on the page as shown in Figure 98, the Add
rule for the view ViewDefault window appears as shown in Figure 101.
2. Configure the parameters, and click Apply to add the rule for the view. Table 43 describes the
configuration items for creating an SNMP view.
To Next Page
Loading...
Need help?
General
