32
IRF stack management
The HP V1910 IRF stack management feature enables you to configure and monitor a stack of connected
HP V1910 switches by logging in to one switch in the stack, as shown in Figure 20.
IMPORTANT:
The HP V1910 IRF stack management feature does not provide the functions of HP Intelligent Resilient
Framework (IRF) technology. To avoid confusion, IRF stack management is simply called stack
management in this document.
Figure 20 Network diagram for stack management
To set up a stack, you must log in to one switch to create the stack, and this switch is the master for the
stack, and you configure and monitor all other member switches on the master switch. The ports that
connect the stack member switches are called stack ports.
Configuring stack management
Stack management configuration task list
Perform the tasks in Table 6 to configure stack management.
Table 6 Stack management configuration task list
Task Remarks
Configuring
the master
switch of a
stack
Configuring global
parameters of a
stack
Required
Configure a private IP address pool for a stack and establish the stack,
and meantime the switch becomes the master switch of the stack.
By default, no IP address pool is configured for a stack and no stack is
established.
To Next Page
Loading...
Need help?
General