Creating a link aggregation group
Required
Create a dynamic aggregate interface and configure
member ports for the dynamic aggregation group
automatically created by the system when you create the
aggregate interface. LACP is enabled automatically on all the
member ports.
By default, no link aggregation group exists.
Displaying information of an aggregate
interface
Optional
Perform this task to view detailed information of an existing
aggregation group.
Setting LACP priority
Optional
Perform the task to set LACP priority for the local system and
link aggregation member ports.
Changes of LACP priorities affect the Selected/Unselected
state of link aggregation member ports.
The default port LACP priority and system LACP priority are
both 32768.
Displaying information of LACP-enabled ports
Optional
Perform the task to view detailed information of
LACP-enabled ports and the corresponding remote (partner)
ports.
Creating a link aggregation group
Select Network > Link Aggregation from the navigation tree, and click the Create tab to enter the page
as shown in Figure 176.
To Next Page
Loading...
Need help?
General