HP V1910 Switch Series User Manual

205
Figure 176 Create a link aggregation group
Table 83 Configuration items of creating a link aggregation group
Item Descri
p
tion
Enter Link Aggregation Interface ID
Assign an ID to the link aggregation group to be created.
You can view the result in the Summary list box at the bottom of the
page.
Specify Interface Type
Set the type of the link aggregation interface to be created:
 Static (LACP Disabled)
 Dynamic (LACP Enabled)
Select port(s) for the link aggregation
interface
Select one or multiple ports to be assigned to the link aggregation
group from the chassis front panel.
You can view the result in the Summary list box at the bottom of the
page.
Return to Static aggregation group configuration task list.
Return to Dynamic aggregation group configuration task list.

HP V1910 Switch Series Specifications

General

Product Series	V1910
VLAN Support	Yes
QoS	Yes
Ports	8, 24, or 48 10/100/1000 ports
MAC Address Table Size	8K entries
Power Supply	Internal power supply
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% (non-condensing)