HP V1910 Switch Series User Manual

393
 Click Apply.
# Retrieve the CRL.
 After retrieving a local certificate, select the CRL tab.
 Click Retrieve CRL of the PKI domain of torsa, as shown in Figure 372.
Figure 372 Retrieve the CRL
Configuration guidelines
When you configure PKI, note the following guidelines:
 Make sure the clocks of entities and the CA are synchronous. Otherwise, the validity period of
certificates will be abnormal.
 The Windows 2000 CA server has some restrictions on the data length of a certificate request. If the
PKI entity identity information in a certificate request goes beyond a certain limit, the server will not
respond to the certificate request.
 The SCEP plug-in is required when you use the Windows Server as the CA. In this case, you need
to specify RA as the authority for certificate request when configuring the PKI domain.
 The SCEP plug-in is not required when you use the RSA Keon software as the CA. In this case, you
need to specify CA as the authority for certificate request when configuring the PKI domain.

HP V1910 Switch Series Specifications

General

Product Series	V1910
VLAN Support	Yes
QoS	Yes
Ports	8, 24, or 48 10/100/1000 ports
MAC Address Table Size	8K entries
Power Supply	Internal power supply
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% (non-condensing)