HP V1910 Switch Series - Configuration Guidelines

211
 Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 on the chassis
front panel.
 Click Apply.
2. Approach 2: Create a dynamic link aggregation group
# Create dynamic link aggregation group 1.
Select Network > Link Aggregation from the navigation tree, and click the Create tab to enter the page
as shown in Figure 182.
Figure 182 Create dynamic link aggregation group 1
 Set the link aggregation interface ID to 1.
 Select the Dynamic (LACP Enabled) option as the aggregate interface type.
 Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 on the chassis
front panel.
 Click Apply.
Configuration guidelines
Follow these guidelines when configuring a link aggregation group: