HP V1910 Switch Series - Configuration Examples; Local Port Mirroring Configuration Example

77
Return to Local port mirroring configuration task list.
Configuration examples
Local port mirroring configuration example
Network requirements
 Department 1 accesses Switch C through GigabitEthernet 1/0/1.
 Department 2 accesses Switch C through GigabitEthernet 1/0/2.
 Server is connected to GigabitEthernet 1/0/3 of Switch C.
Configure port mirroring to monitor the bidirectional traffic of Department 1 and Department 2 on the
server.
To satisfy the requirement through local port mirroring, perform the following configuration on Switch C:
 Configure GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 as mirroring ports.
 Configure GigabitEthernet 1/0/3 as the monitor port.
Figure 61 Network diagram for local port mirroring configuration
Configuration procedure
# Create a local mirroring group.
Select Device > Port Mirroring from the navigation tree and click Create to enter the page for creating
mirroring groups, as shown in Figure 62.