HP V1910 Switch Series User Manual

59
Device maintenance
Software upgrade
A system software image file is used to boot the device. Software upgrade allows you to obtain a target
system software image file from the local host and set the file as the startup configuration file. In addition,
you can select whether to reboot the device to bring the upgraded system software image file into effect.
CAUTION:
Software upgrade takes some time. Avoid performing any operation on the web interface during the
upgrading procedure. Otherwise, the upgrade operation may be interrupted.
Select Device > Device Maintenance from the navigation tree to enter the software upgrade configuration
page, as shown in Figure 45.
Figure 45 Software upgrade configuration page
Table 18 Software upgrade configuration items
Item Descri
p
tion
File
Specifies the filename of the local system software image file, which must be with an
extension .bin.
Filename
Specifies a filename for the file to be saved on the device. The filename must have
an extension, which must be the same as that of the source file.
File Type
Specifies the type of the startup configuration file:
 Main
 Backup

HP V1910 Switch Series Specifications

General

Product Series	V1910
VLAN Support	Yes
QoS	Yes
Ports	8, 24, or 48 10/100/1000 ports
MAC Address Table Size	8K entries
Power Supply	Internal power supply
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% (non-condensing)