HP V1910 Switch Series - Modifying a VLAN Interface

147
Figure 134 The Create tab
Table 56 Configuration items of creating a VLAN interface
Item Descri
p
tion
Input a VLAN ID:
Input the ID of the VLAN interface to be created. Before creating a VLAN
interface, make sure that the corresponding VLAN exists.
Configure
Primary IPv4
Address
DHCP Configure the way in which the VLAN interface obtains an IPv4 address.
Allow the VLAN interface to automatically obtain an IP address by selecting
the DHCP or BOOTP option, or manually assign the VLAN interface an IP
address by selecting the Manual option.
BOOTP
Manual
IPv4 Address
Configure an IPv4 address for the VLAN interface.
This option is available after you select the Manual option.
Mask Length
Select the subnet mask length.
This option is available after you select the Manual option.
Return to VLAN interface configuration task list.
Modifying a VLAN interface
NOTE:
After you modify the IPv4 address for a selected VLAN interface on the page for modifying VLAN
interfaces, click the Apply button to submit the modification.
After you chan
g
e the IP address of the VLAN interface you are usin
g
to lo
g
in to the device, you will be
disconnected from the device. You can use the changed IP address to re-log in.
Select Network > VLAN Interface from the navigation tree and click the Modify tab to enter the page
shown in Figure 135.