HP V1910 Switch Series User Manual

122
Table 45 Configuration items for creating an SNMP group
Item Descri
p
tion
Group Name Set the SNMP group name.
Security Level
Select the security level for the SNMP group. The available security levels are:
 NoAuth/NoPriv—No authentication no privacy.
 Auth/NoPriv—Authentication without privacy.
 Auth/Priv—Authentication and privacy.
IMPORTANT:
For an existing SNMP group, its security level cannot be modified.
Read View Select the read view of the SNMP group.
Write View
Select the write view of the SNMP group.
If no write view is configured, the NMS cannot perform the write operations to all MIB
objects on the device.
Notify View
Select the notify view of the SNMP group, that is, the view that can send trap
messages.
If no notify view is configured, the agent does not send traps to the NMS.
ACL
Associate a basic ACL with the group to restrict the source IP address of SNMP
packets, that is, you can configure to allow or prohibit SNMP packets with a specific
source IP address, so as to restrict the intercommunication between the NMS and the
agent.
Return to SNMPv3 configuration task list.
Configuring an SNMP user
1. Select Device > SNMP from the navigation tree.
2. Click the User tab to enter the page as shown in Figure 106.
3. Click Add to enter the Add SNMP User page, as shown in Figure 107.
Figure 106 SNMP user

HP V1910 Switch Series Specifications

General

Brand	HP
Model	V1910 Switch Series
Category	Switch
Language	English