HP V1910 Switch Series - Configuring an SNMP Community

120
Figure 101 Add rules to an SNMP view
NOTE:
You can also click the
icon corresponding to the specified view on the page as shown in Figure 98,
and then you can enter the page to modify the view.
Return to SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list.
Configuring an SNMP community
1. Select Device > SNMP from the navigation tree.
2. Click the Community tab to enter the page as shown in Figure 102.
3. Click Add to enter the Add SNMP Community page as shown in Figure 103.
Figure 102 Configure an SNMP community
Figure 103 Create an SNMP Community