HP V1910 Switch Series - PKI configuration

Configuring RADIUS servers
From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration page
appears, as shown in Figure 332.
Figure 332 RADIUS server configuration
Table 130 RADIUS server configuration
Item Descri
p
tion
Server Type
Specify the type of the server to be configured, which can be Authentication
Server and Accounting Sever.
Primary Server IP
Specify the IP address of the primary server.
If no primary server is specified, the text box displays 0.0.0.0.
To remove the previously configured primary server, enter 0.0.0.0 in the text
box.
The specified IP address of the primary server cannot be the same as that of the
secondary server.
Primary Server UDP Port
Specify the UDP port of the primary server.
If the IP address of the primary server is not specified or the specified IP address
is to be removed, the port number is 1812 for authentication or 1813 for
accounting.
Primary Server Status
Set the status of the primary server, including:
 active: The server is working normally.
 blocked: The server is down.
If the IP address of the primary server is not specified or the specified IP address
is to be removed, the status is blocked.
Secondary Server IP
Specify the IP address of the secondary server.
If no secondary server is specified, the text box displays 0.0.0.0.
To remove the previously configured secondary server, enter 0.0.0.0 in the text
box.
The specified IP address of the secondary server cannot be the same as that of
the primary server.