HP V1910 Switch Series - Displaying Information of LACP-Enabled Ports

207
Figure 178 The Setup tab
After finishing each configuration item, click the right Apply button to submit the configuration.
Table 85 describes the configuration items.
Table 85 LACP priority configuration items
Item Descri
p
tion
Select LACP enabled port(s) parameters Set a port LACP priority.
Select port(s) to apply Port Priority
Select the ports where the port LACP priority you set will
apply on the chassis front panel.
You can set LACP priority not only on LACP-enabled ports but
also on LACP-disabled ports.
System Priority Set the LACP priority of the local system.
Return to Dynamic aggregation group configuration task list.
Displaying information of LACP-enabled ports
Select Network > LACP from the navigation tree. The Summary tab is displayed by default, as shown in
Figure 179.