HP V1910 Switch Series User Manual

260
Default route
A default route is used to forward packets that match no entry in the routing table. Without a default route,
the packet is discarded.
An IPv4 static default route has both its destination IP address and mask being 0.0.0.0.
Configuring IPv4 routing
Displaying the IPv4 active route table
Select Network > IPv4 Routing from the navigation tree to enter the page shown in Figure 226.
Figure 226 Active route table
Table 104 Description of the fields of the active route table
Field Descri
p
tion
Destination IP Address Destination IP address of the route
Mask Mask of the destination IP address
Protocol Protocol that discovered the route
Preference
Preference value for the route
The smaller the number, the higher the preference.
Next Hop Next hop IP address of the route
Interface
Output interface of the route. Packets destined for the destination IP
address will be forwarded out the interface.

HP V1910 Switch Series Specifications

General

Brand	HP
Model	V1910 Switch Series
Category	Switch
Language	English