HP V1910 Switch Series User Manual

123
Figure 107 Create an SNMP user
Table 46 Configuration items for creating an SNMP user
Item Descri
p
tion
User Name Set the SNMP user name.
Security Level
Select the security level for the SNMP group. The following are the
available security levels:
 NoAuth/NoPriv—No authentication no privacy.
 Auth/NoPriv—Authentication without privacy.
 Auth/Priv—Authentication and privacy.
Group Name
Select an SNMP group to which the user belongs.
 When the security level is NoAuth/NoPriv, you can select an
SNMP group with no authentication no privacy.
 When the security level is Auth/NoPriv, you can select an SNMP
group with no authentication no privacy or authentication
without privacy.
 When the security level is Auth/Priv, you can select an SNMP
group of any security level.
Authentication Mode
Select an authentication mode (including MD5 and SHA) when the
security level is Auth/NoPriv or Auth/Priv.
Authentication Password
Set the authentication password when the security level is
Auth/NoPriv or Auth/Priv.
The confirm authentication password must be the same with the
authentication password.
Confirm Authentication Password
Privacy Mode
Select a privacy mode (including DES56, AES128, and 3DES)
when the security level is Auth/Priv.
Privacy Password Set the privacy password when the security level is Auth/Priv.

HP V1910 Switch Series Specifications

General

Product Series	V1910
VLAN Support	Yes
QoS	Yes
Ports	8, 24, or 48 10/100/1000 ports
MAC Address Table Size	8K entries
Power Supply	Internal power supply
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% (non-condensing)