HP V1910 Switch Series User Manual

404
Figure 382 The page for creating a time range
Table 148 describes the configuration items for creating a time range.
Table 148 Time range configuration items
Item Descri
p
tion
Time Range Name Set the name for the time range.
Periodic
Time Range
Start Time Set the start time of the periodic time range.
You can define
both a periodic
time range and
an absolute
time range to
create a
compound time
range. This
compound time
range recurs on
the day or days
of the week
only within the
specified
period.
End Time
Set the end time of the periodic time range. The end time must
be greater than the start time.
Sun, Mon,
Tue, Wed,
Thu, Fri,
and Sat.
Select the day or days of the week on which the periodic time
range is valid. You can select any combination of the days of
the week.
Absolute
Time Range
From
Set the start time and date of the absolute time range. The time
of the day is in the hh:mm format (24-hour clock), and the date
is in the MM/DD/YYYY format.
To
Set the end time and date of the absolute time range. The time
of the day is in the hh:mm format (24-hour clock), and the date
is in the MM/DD/YYYY format. The end time must be greater
than the start time.
Return to IPv4 ACL configuration task list.

HP V1910 Switch Series Specifications

General

Product Series	V1910
VLAN Support	Yes
QoS	Yes
Ports	8, 24, or 48 10/100/1000 ports
MAC Address Table Size	8K entries
Power Supply	Internal power supply
Jumbo Frame Support	Yes
Operating Humidity	10% to 90% (non-condensing)