HP V1910 Switch Series User Manual

50
Configuration procedure
1. Configure Device A
# Configure the local clock as the reference clock, with the stratum of 2. Enable NTP authentication, set
the key ID to 24, and specify the created authentication key aNiceKey as a trusted key. (Configuration
omitted.)
2. Configure Switch B
# Configure Device A as the NTP server of Switch B.
 Select Device > System Time from the navigation tree, and then select the Net Time tab to perform
the configurations as shown in Figure 37.
Figure 37 Configure Device A as the NTP server of Switch B
 Select NTP.
 Type 24 in the ID box, and type aNiceKey in the Key String text box for key 1.
 Type 1.0.1.11 in the NTP Server 1 text box and type 24 in the Reference Key ID text box.
 Click Apply.
3. Verify the configuration
After the above configuration, you can see that the current system time on Device A is the same as Switch
B.

HP V1910 Switch Series Specifications

General

Brand	HP
Model	V1910 Switch Series
Category	Switch
Language	English