Huawei ECC800-Pro - Commissioning the Elight (for Fusionmodule800)

Item Alarm Severity
Selection
Description
None The eLight strip light is steady
blue (atmosphere light).
NOTE
After you set the alarm severity, the eLight indicator is o if no alarm is generated.
5.7 Commissioning the eLight (for FusionModule800)
When the system type is FusionModule800 an eLight is installed, perform the
following steps to congure it.
Procedure
Step 1 Ensure that the device address of the eLight actuator is the default value 2.
Toggle switches 1 to 4 of the DIP switch specify the device address in binary mode.
ON indicates 1, and OFF indicates 0.
Table 5-9 Setting a device address
Address
Toggle
Switch 1
Toggle
Switch 2
Toggle
Switch 3
Toggle
Switch 4
1 ON OFF OFF OFF
2 OFF ON OFF OFF
3 ON ON OFF OFF
4 OFF OFF ON OFF
Step 2 Add an eLight.
1. Log in to the ECC800-Pro WebUI as an administrator.
2. Add an eLight.
Table 5-10 Adding an eLight
Path
Parameter Setting
Choose System
Settings > Device
Management and click
Add Device. The
parameters for adding
devices are displayed.
Device
attribute
Select eLight Actuator from the
drop-down list box.
Device Type Select eLight Actuator from the
drop-down list box.
ECC800 Data Center Controller
User Manual (for ECC800-Pro) 5 Power-On Commissioning
Issue 02 (2020-09-07) Copyright © Huawei Technologies Co., Ltd. 118