Huawei ECC800-Pro - Commissioning an Access Control Device and a Cabinet Electronic Lock

Table 6-8 Function check
Check Method Normal Connection Status
Open the cabinet door. Door1 DI alarm is generated on the active
alarm page of the app or WebUI.
----End
6.4.2 Commissioning an Access Control Device and a Cabinet
Electronic Lock
If an access control device and cabinet electric lock are installed, perform the
following steps to
congure it.
Prerequisites
When the
ngerprint reader is connected to the ECC800-Pro for the rst time, the
permissions need to be synchronized.
Procedure
Step 1 Set the access user management and access permission management.
1. Choose System Settings > Access Management to access the access
management page. The system supports the management of various access
permissions through the access card, password, and
ngerprint.
2. Click Authentication Mode and set the authorization mode for the smart
module actuator or access actuator.
Select Card, Fingerprint, Card and password, Card and
ngerprint,
Fingerprint and password, Card, password and
ngerprint or Card,
password or ngerprint.
NO TE
The following describes how to set the access actuator.
ECC800 Data Center Controller
User Manual (for ECC800-Pro) 6 Feature Description
Issue 02 (2020-09-07) Copyright © Huawei Technologies Co., Ltd. 136